Electrothermal Servo Controls for Shutter Valves

100-300000 INR/Unit

Get a Price/Quote

Product Details:

Click to View more
Share Your Product:

Request to Call Back Send Inquiry

Electrothermal Servo Controls for Shutter Valves Price And Quantity

Price 100-300000 INR/Unit
Minimum Order Quantity 1 Unit

Electrothermal Servo Controls for Shutter Valves Trade Information

Supply Ability 100 Unit Per Month
Delivery Time 1 Week

Product Description

Electrothermal Servo Controls for Shutter Valves Series V3EC

MAIN CHARACTERISTICS : V3EC servocontrols have been designed for use on domestic heating and cooling systems, where compact dimensions and ease of assembly are required. The closing force of the valve stem is guaranteed by a spring couple to a wax expansion element. To motorise the manually controlled shutter valves, predisposed to be controlled by these servocontrols it is sufficient to unscrew the manual knob completely and screw the ring nut of the actuator for the quick coupling to the servocontrol. All this is done without having to drain the system (see table 3 for the valves predisposed for these servocontrols).

Model :		V3EC/60/230/00

Operating mode		two points (on-off)
Shaft position when not fed		normally closed
Voltage		24V AC 230V AC
Frequency		5060 Hz
Peak Current		150mA
Power absorbed at steady operating speed		3.5W - 3W
Cable length		approx. 1000mm
Minimum travel/ Maximum travel		6mm/8mm
Shutter shaft ascent travel time		minimum 300s
Shutter shaft descent travel time		minimum 300s
Force exerted by the shutter shaft During descent travel		90N 15%
Degree of protection EN 60529		IP 40
Minimum and maximum environment temperature		60C
Overall dimensions		57mm 52mm 47mm
Casing material		PA self-extinguishing VO
Auxiliary microswitch		5A125VAC-3A250VAC
Valve connection		Threaded ring nut M30 1.5

Distance between the valve body rabbet and of the shutter shaft in low position = A 11

Distance between the valve body rabbet and of the shutter shaft in high position= A 17, 5

INSTALLATION Remote the handwheel or the cap from the valve body. Install the actuator, exerting light pressure, and screw the knurled ring nut of the actuator onto the valve body. Do not use spanners, box wrenches or similar tools. Make the electrical connection. Important notes for maintenance. The power cable must never be replaced. Opening the actuators will cause irreparable damage to the device. Faulty actuators must be completely replaced. Warnings. The actuator must NOT be installed below the valve body.